М. В. Главатских

Часть публикаций из профиля, по году от новых к старым. Это не полный список последних работ автора; работы без года — в конце.

• Novel cast heat resistant crossover Al-Zn-Mg-Cu-Y-Zr-Cr alloy with improved corrosion and wear behavior, and low thermal expansion2025
• High hardening effect and formation of three types precipitates in the Al-0.3Zr-0.3Gd(Yb) with Fe and Si impurities2025
• Competing recovery and recrystallization with precipitation hardening under annealing of Al-Zr-Gd(Yb) with Fe and Si impurities obtained by different thermo-mechanical treatment2025
• Influence of impurities and cooling rate on the microstructure and phase composition of new Al–3.5Zn–3.5Mg–3.5Cu–Y(Er)–Zr–Cr alloys in as-cast and homogenized states2025
• Effect of iron and silicon impurities on the phase composition and hardening of Al-0.3Zr-REM (REM = Er, Y, Yb, Gd) alloy ingots during annealing2025
• ВЛИЯНИЕ ПРИМЕСЕЙ И СКОРОСТИ ОХЛАЖДЕНИЯ НА МИКРОСТРУКТУРУ И ФАЗОВЫЙ СОСТАВ НОВЫХ СПЛАВОВ Al–3,5Zn–3,5Mg–3,5Cu–Y(Er)–Zr–Cr В ЛИТОМ И ГОМОГЕНИЗИРОВАННОМ СОСТОЯНИЯХ2025
• Microstructure and Phase Composition of Novel Crossover Al-Zn-Mg-Cu-Zr-Y(Er) Alloys with Equal Zn/Mg/Cu Ratio and Cr Addition2024 · аннотациясвернуть

  The effect of 0.2%Cr addition on the structure, phase composition, and mechanical properties of the novel cast and wrought Al-2.5Zn-2.5Mg-2.5Cu-0.2Zr-Er(Y) alloys were investigated in detail. Chromium is distributed…

• Novel Cast and Wrought Al-3Zn-3Mg-3Cu-Zr-Y(Er) Alloys with Improved Heat Resistance2023 · аннотациясвернуть

  The main weaknesses of commercial high-strength Al-Zn-Mg-Cu-based alloys are the low casting properties, corrosion and heat resistance. Al-Zn-Mg-Cu-based alloys with Zn/Mg ratio equal to 1 combine good strength,…